3DPrinting

Looks like textbook too close to the bed. What firmware are you running, are you able to baby step while printing? Also what filament are you printing?

As others have said, almost certainly nozzle too close to bed. Check your printer for a Z offset setting and click it up .1 or so.

Just to comment a bit:

I think this is one of the casualties of "the paper method" being so poorly defined (because oldhats gotta gatekeep the hobby). People eventually learn WHAT the paper trick is (lower the nozzle until you can JUST slip a piece of paper between it and the bed) but not the next step which is to then step back "one step". Which.. also can end horribly because different printers have different dZ and people forget that their layer height is generally O(0.1 mm). So if you are doing 0.2 mm layers and your nozzle is 0.05 mm from the bed...

When I was learning I definitely made that mistake. Had poor bed adhesion and eventually learned about The Paper Method. Did that and thought I was smug and then... no prints worked and I had to clean my nozzle every time. Eventually found the last step and then looked at the number of what dZ was. Was useful because it means I actually understand how first layers work. Was obnoxious for all the obvious reasons.

Its why I really like that the more newbie friendly outlets and channels are increasingly suggesting using feeler gauges instead. That has other problems (people not realize there are error bars around that 0.3025 mm gauge...) but it provides a much more reproducible method (and can be semi-automated if you have a multimeter and some tape).

My first guess would be your first layer is too low, just cuz the wrinkles usually imply too much material so it has to wrinkle up to make room.

Is 120% Normal for first layer?

Loos to me like overextrusion on the first layer. Mayhaps lower that first layer line width and check z offset. Also check esteps and extrusion multiplier.

First layer too close as everyone has said, but I’ve also seen that effect when the flow rate is too high.

Are you letting your bed soak (sit heated up) before probing? Beds warp as they heat and if you start probing immediately after it comes to temp the shape of the bed will likely change as it settles.

Is there a lot of crackling from the nozzle? It's heard of some filament absorbing trace bits of water that can cause gaps and bubbles like that.