3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: [email protected] or [email protected]
There are CAD communities available at: [email protected] or [email protected]
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
I got tired of the paper method and adjusting the screws by the auto-leveling results as I could never get them to be consistent. Now I used mechanical level indicator and got these consistent values indicating that the bed is tilted to the right/left?
To my suprise it can actually print something like this but what would cause these values? My suspicion is that the Z axis is sagging but I would like to get some opinions before completely reassembling the printer.
It is already at the lowest it can be but I'll try raising the right side again
I'd suggest loosening all the bed screws as much as is practical and then redoing the mesh. That way you've got lots of room to lower high spots.
If the tilt is too extreme, you might also be dealing with a sagging gantry. I'm not familiar with your printer model so I don't know how likely that is or how you'd go about fixing it though I'm afraid.