3DPrinting

15178 readers

165 users here now

3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.

The r/functionalprint community is now located at: [email protected] or [email protected]

There are CAD communities available at: [email protected] or [email protected]

Rules

No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts

If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![](URL)

Moderation policy: Light, mostly invisible

founded 1 year ago

MODERATORS

What is causing this pattern in the first layer? (lemmy.world)

submitted 1 year ago* (last edited 1 year ago) by rexxit to c/3dprinting

25 comments fedilink hide all child comments

Flashforge creator pro 2 with PLA, standard quality preset, textured removable magnetic bed on the build plate.

The first lines are straight, but as it makes more parallel lines to build the layer, it starts to develop a scalloped pattern. This creates issues with smoothness when it fills back to join it from the other side later. I've leveled the build plate, although I suspect it's not perfectly flat and maybe slightly higher in the middle. Is this my problem? It appears to have the pattern even away from the middle if that makes sense.

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 5 points 1 year ago (1 children)

Probably too close to the bed. The gap between your nozzle and your printing surface isn't big enough, so some of the filament isn't able to escape and builds up in blobs. Check if the patters's any worse/more noticeable towards the middle.

[–] rexxit 2 points 1 year ago* (last edited 1 year ago) (1 children)

In the case that is an uneven bed, where the middle is slightly high/convex, how do people fix that? I've calibrated it twice, but I think it's still too close in the middle while the standard calibration locations (front center, back left, back right) are perfect

[–] [email protected] 1 points 1 year ago (1 children)

Glass bed mods (glass is always dead flat) or careful adjustments of screws and tramming of the bed, depending on your printer design. Or find a way to sample more points when leveling the bed to compensate for the unevenness. (I have a Snapmaker 2, which shipped with a firmware bug relating to levelling that wasn't found for quite a long time. Those were the most common fixes and mitigations.)

[–] [email protected] 1 points 1 year ago

Glass is not always flat speaking as someone who just swapped their stock glass bed due to warpage (>0.4mm). My new aluminum bed is now within 0.01mm from side to side.