3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or [email protected]
There are CAD communities available at: [email protected] or [email protected]
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
Hey y'all, I managed to hack together a printer from scratch and I'm struggling to get it to print well. It's a CoreXY system that's being controlled by a Octopus 1.1. Dual z screws, the works.
I have it moving under it's own power and all. It's able to actually print, but the results are atrocious.
I'm just trying to diagnose what's wrong here.
The bottom/first layer actually looks kinda good. It's just completely shredding subsequent layers.
Any advice would be appreciated!
You z-step might be off. I.e. z is moving too far each layer.
I realize I'm reviving a super old post here, but I actually did end up figuring out what it was. I posted a little writeup in here if you're at all curious. You were actually kinda close.
I think you might be onto something but the other direction. I think it's not moving quite enough per layer.
You could try moving Z to +100mm and just measure with a ruler to make sure it's at least in the correct range.
I think I'll give that a swing. Thanks for your input!