3DPrinting

15803 readers

55 users here now

3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.

The r/functionalprint community is now located at: or [email protected]

There are CAD communities available at: [email protected] or [email protected]

Rules

No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts

If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![](URL)

Moderation policy: Light, mostly invisible

founded 2 years ago

MODERATORS

209

I Designed a 3D Printable Balisong Knife (lemmy.world)

submitted 1 year ago by dual_sport_dork to c/3dprinting

30 comments fedilink hide all child comments

We've been having a good old time with this over on the Pocket Knife community, but I figure there's probably a lot of crossover with this crowd as well.

I'm sure you've seen various clever little one piece utility knife blade holders on Thingiverse and so forth, and while they're quite functional I don't think they're nearly as overwrought or silly enough, nor require quite enough components.

Rather than repeat my entire post from there over here, I'll leave you with these:

Link to Project Annoucement

Link to .STL Files And Assembly Instructions

you are viewing a single comment's thread
view the rest of the comments

[–] dual_sport_dork 2 points 1 year ago

The chamber is not heated per se, but if you cap it off with the included lid the bed heater can raise the internal temperature quite a bit. There is no PID for the chamber temp, though. It just winds up being whatever it is due to the waste heat feom the bed and extruder. You can't actually control it.

That said, I have printed ABS with it no problem. I have a roll of PA-CF, but haven't unwrapped it yet because I'm still chicken.