I have spent weeks of tuning PETG to print on my modified CR-10. I would get regular failures and really stringy prints. I had trouble getting it to stick to the bed, and could only print really slowly.
I was dreading trying ASA, but I bought a roll of Polylite ASA, put it on the printer without drying it, and used a default ASA profile I found online (I didn't even start with a temp tower). The only changes I made was a minimum layer fan of 10% as my PETG fan shroud needs constant cooling. I didn't see anything about enclosure temperature so I left it at 40°.
The first print started great but broke off the bed. The Z height was off and I didn't get it fixed until the first layer was halfway done. This benchy is the second print using a default ASA profile, no tuning.
I feel like I've wasted my time with PETG. This material has been so much easier to print.
Edit: not sure why my image didn't upload. I'm new to Jerboa.
Maybe slight overextrusion looking at the bow sides. Needs retraction tuning as well, looking at the smokestack.
Yeah it's not perfect, but I didn't do any tuning at all, and I was running at a faster speed than I normally run for a warping material.