3DPrinting
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or [email protected]
There are CAD communities available at: [email protected] or [email protected]
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
view the rest of the comments
Good luck! I am about 2 months into my 2.4 R2 build. My kids are younger and life is busy, so I'm lucky to get an hour or two every few days to chip away at it. I have everything but my panels on and wiring is done, so I should be powering it up soon.
The build is pretty straightforward. The only real gotcha that I ran into was missing the occasional printed part and not paying enough attention when grabbing 16T and 20T pullies. My generic cable chains were too short, but other than that all the parts fit exactly as intended.