3DPrinting
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or [email protected]
There are CAD communities available at: [email protected] or [email protected]
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
view the rest of the comments
I have more terminals to swap in but I'll be replacing the board anyway. The other identical board never did this but I also never tried pushing the limits on that one.
I had an issue I caught early when I swapped my prusa from a Rambo to an skr mini, used the same power wires which didn't have ferrules, I got "lucky" that the power supply shut itself down, one wire had worked itself a bit loose, enough to potentially arc.
I've replaced everything with new 14 awg wire with solid ferrules and I inspect semi regularly, I trust my crimps here but I don't mess around with potential fire hazards. I think there's a tendency to think, oh it's low voltage, it's fine, but there's a lot of energy going through those wires, treat it with the same respect you would mains power. Take your time, double check everything, and invest in good crimping tools.