3DPrinting
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or [email protected]
There are CAD communities available at: [email protected] or [email protected]
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
view the rest of the comments
The Ender 3 is the printer I recommend new users get. It's open source hardware and firmware, the devices can be found for as little as $20 sometimes. Bambu Studio, UltiMaker Cura, and PrusaSlicer, and probably loads more are all awesome slicer software that is compatible with a LARGE number of 3D printers.
more info for people leaning towards ender: ender 3's need to have their wiring fixed by removing tinned ends from wires in screw terminals and either putting them in bare or with crimped ferrules to reduce fire hazard. The heat break should also be swapped for all/bi metal one that puts the ptfe tube out of the melt zone as it will continually degrade from the heat and lead to problems a newbie probably can't diagnose. and the bed mounts suck, and the build plate once petg gouges it out, and the extruder when the tension arm inevitably snaps, and the list goes on...
that said I have 3 now. 2 were acquired for free. One is a switchwire conversion, one is ender NG, and the other is kevinakasam belt modded. I would recommend both mods that are not the switchwire for cost to improvement ratio.
Ender is a horrible introduction to printing far too much tinkering and manual calibration. Bambu A1 is the way to go now.