3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or [email protected]
There are CAD communities available at: [email protected] or [email protected]
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
The #3DBenchy model usually capsizes in water, but I found that with the right slicer settings, it will actually float upright: https://www.thingiverse.com/thing:6076719
I've gotten it to float upright with surface tension before using some custom slicing in Cura. But once the inside gets wet, it no longer stays up.
I basically did 100% on the bottom aft, and 8% everywhere else. Still doesn't float that well.
Right slicer Settings as in “correct”? Is the intention of Benchy to float upright if your printer is tuned correctly?
Benchy was not designed to float. An STL file only defines the external geometry, but if you print it with default slicer settings, the density will be relatively constant throughout, and the resulting center of gravity is too high and too far forward to function as a boat.
In order to make it float, I put more mass at the bottom/rear and less at the top.
I would say definitely not intended considering the linked page mentions very specific slicing but it’s cool nonetheless!