3DPrinting
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or [email protected]
There are CAD communities available at: [email protected] or [email protected]
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
view the rest of the comments
Extrusion is a mix of temperature, feed rate, speed and pressure.
Basically the hotend temp could be high enough that the plastic melts but it still “pushes” just fast enough to build pressure to drive it. Not too much, otherwise the filament grinds and extruder skips, but at the right amount you can keep up with the feed.
The nozzle, lifted up a bit, moves slow enough that the filament comes out and spreads out from the pressure pushing on it. Making the line wide and tall.
The dance is keeping those in sync. Move too fast and the lines are thin, too slow and they’re too wide.
Nozzle too high and it doesn’t blend into the layer below as much as sit on top. Too low and the extra pressure pushes the filament around and it curls back up onto the nozzle.