3DPrinting

15797 readers

366 users here now

3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.

The r/functionalprint community is now located at: or [email protected]

There are CAD communities available at: [email protected] or [email protected]

Rules

No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts

If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![](URL)

Moderation policy: Light, mostly invisible

founded 2 years ago

MODERATORS

What's going wrong with my prints? (self.3dprinting)

submitted 9 months ago by Psymonkee to c/3dprinting

16 comments fedilink hide all child comments

Hey,

Still fairly new to this hobby and have lots of ideas but I've got a snag with a few prints now and was hoping someone could help me work out what I'm doing wrong.

The project is small trays for a custom advent calendar but as you can see the corner on the second picture has lifted massively.

A 3d printed tray in grey with a handle.

This has happened before with a different print too and I never solved that issue either.

Using an Ender 3 Pro with some generic filament from amazon, hot end at 200C (goes stringy any higher), bed was 50C for this print I think.

Any help would be wonderful :)

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 1 points 9 months ago

Unsure if it's due to not being clean or a levelling issue

It can be both. To exclude bent X axis or bed, I think its best to get nozzle close to the bed, then observe the gap while moving head in XY. Light can help with good angle as well as getting your eye close to the nozzle 👁️