3DPrinting

15661 readers

74 users here now

3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.

The r/functionalprint community is now located at: [email protected] or [email protected]

There are CAD communities available at: [email protected] or [email protected]

Rules

No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts

If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![](URL)

Moderation policy: Light, mostly invisible

founded 2 years ago

MODERATORS

Major issues with klipper and bed levelling (feddit.dk)

submitted 9 months ago* (last edited 9 months ago) by [email protected] to c/3dprinting

15 comments fedilink hide all child comments

I recently made the switch from the marlin-based stock firmware on my anycubic kobra 2, to klipper. I didn't have issues with bed levelling or first layer on the stock firmware, but I'm having significant issues running klipper. The bed is uneven, the probed mesh shows a deviation of 0.197mm, it was the same when running stock FW+octoprint.

But it seemed to be correcting just fine for this on the stock FW. I got a consistent decent first layer across the entire bed.

With klipper, it's absolutely impossible to get it to correct for this unevenness. Half the bed will get perfect first layer, but then the second half is either way too squished or hardly connecting to the bed. And it's causing further issues as it's also hitting the print when moving, despite having Z-hop of 0.3mm for travel moves.

What the hell is going on? How do I fix this?

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 6 points 9 months ago* (last edited 9 months ago) (1 children)

Looks like you have it set to load the profile "default" instead of "bed60"

Also worth asking, did you have your start gcode set in your slicer previously and if so, did you delete it out of there now that you're using klipper macros?

For me, in Cura, I simply have START_PRINT and END_PRINT in the start/end fields in the Cura settings. Based on your macro title, it would be PRINT_BEGIN and PRINT_END

[–] [email protected] 3 points 9 months ago* (last edited 9 months ago) (1 children)

Yeah forgot that I switched to default again to make sure it wasn't something with the different profiles messing it up. I update the mesh before every print now, once it's reached temp.

I did have my start gcode in the slicer before, but that's been replaced with the macro.

[–] [email protected] 3 points 9 months ago (1 children)

I'll try to check mine when I'm back home later. I just use the default profile since I don't ever adjust anything with the bed unless it's out of spec. Even printing at slightly different temps doesn't seem to affect anything as far as bed leveling is concerned.

[–] [email protected] 1 points 9 months ago

Yeah I'm not seeing any significant deviations in the mesh based on temps either.