I received a free broken CR-10S Pro V2 from my cousin, I finally have it repaired well enough to make these nice spiral vases. Here is the full album (not sure how to post albums here yet):
this post was submitted on 30 Jun 2023
23 points (89.7% liked)
3DPrinting
15676 readers
120 users here now
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: [email protected] or [email protected]
There are CAD communities available at: [email protected] or [email protected]
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
What was broken about it?
A whole lot lol. Replaced and heavily modified the extruder, extruder motor, filament runout sensor, bowden tube, hot end cooling fan, and part cooling fan/blower. Also had to take apart the hot end / heat break and clean out leaked globs that had stuck everywhere. Also modified the electronics cooling/intake fan setup with a dc/dc converter and 12v fans to reduce noise.