3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or [email protected]
There are CAD communities available at: [email protected] or [email protected]
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
Prints started to get all wonky about a week ago. I couldn't figure out the problem. Changed the nozzle, tighten the belts, lubed the z screws, and cleaned the carbon fiber rods. Disassembled the extruder and I didn't see any clogging, but when I disassembled the hall sensor, I noticed a lot of wear. Then I found a piece of metal inside the extruder that I suspect broke off from the hall sensor somehow. A new extruder arrived yesterday and the X1C is printing like a champ again.
I had a look too, and they seemed quite affordable. At the risk of sounding pessimistic, :) I think the biggest risk is that they lower quality and raise prices once they get big enough, but hopefully there will be high quality 3rd party parts available by then.