I finally finished model 7 (Buggy) from 3dsets. It was fun to build, but mistake to take it in forest (one screw loose near one rear wheel).
this post was submitted on 25 Sep 2023
135 points (100.0% liked)
3DPrinting
15786 readers
294 users here now
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or [email protected]
There are CAD communities available at: [email protected] or [email protected]
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Sorry! in English “how did/do you find” something also means what is your opinion on something. I meant to ask what do you think of the driveline, is it strong, easy to lubricate, did the parts fit well? I’ve been thinking of building one
I see, thanks for explain.
Driveline is no need to lubricate, because it's belt drive system(at least in Model 7). Parts fit well, bearings, belts etc (although, that depends on how well calibrated is your printer). I think that system is strong enough. I built it with brushless motor and it's wild.
Only challenging parts were ball joints. I had problems to fit them in place, but I found a way.
Awesome thanks for the info! Which filaments did you use?
I wasn't expecting plain PLA! Are there any issues with warping due to heat from the motor?
It's recommended to use PC or ASA for motor parts. I used ASA