How is this possible even with abl? I dont' get it...
this post was submitted on 30 Jul 2023
17 points (100.0% liked)
3DPrinting
15605 readers
205 users here now
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: [email protected] or [email protected]
There are CAD communities available at: [email protected] or [email protected]
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
I'm agree! But look at my picture, how can it be good at some point, and to close at others?
You are too close everywhere. Im not using abl, but dont expect perfection from it. I believe if you increase offset it will be good everywhere. Machine can deal with small error, but not if its too much
Tank you!
When my Ender 3 S1 (not plus) had bed leveling issues, the problem was caused by backlash on the Z axis. It's important that the Z axis be just loose enough that downward motion is driven by gravity. If instead the Z screws have to "pull down" on the gantry, then the height will be too sloppy for ABL to make fine adjustments.