Fourth try on a print. Tried to add some adhesive to the bed to get it to stick better. Watched the first two layers and went to bed. Woke up to a printer on strike.
this post was submitted on 06 Jan 2025
279 points (97.9% liked)
3DPrinting
15897 readers
74 users here now
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or [email protected]
There are CAD communities available at: [email protected] or [email protected]
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
It's a learning experience. Is your nozzle torqued to spec? Only time I've seen something like this is when the heatbreak/nozzle weren't set correctly on a v6 hotend, and even then it just oozed down, didn't consume the entire heatsink. I kept that in my box of learning lol, swapped everything to hotends that are secured so they don't spin freely after that, was petg so it degraded in the heat and was such a pain in the ass to remove from set screws, was ok writing it off.
Bed adhesion is often caused by surface cleanliness in my experience, some setting will influence it but you're going to chase problems if your surface has residual oils, some surfaces are more sensitive to it but even the oils in your fingerprints can cause a loss of adhesion. Light dish soap and water is the general recommendation for a degreaser but be aware that this will damage some surfaces, I've got some that explicitly want only 99% IPA and another that only wants a clean microfibre cloth.
Drafts can cause an issue too, seen some abs fail becauae I didn't have the enclosure latched properly and the doors worked their way open with vibrations from printing, I keep mine in my garage and live in Canada, enclosures are a must for me.