What could cause the strange part on the right? The whole surface should be the same, it's a 90° wall, so nothing that should look like this. Can't see anything strange in OrcaSlicer. BambuLab A1 Mini with Creality PLA+
this post was submitted on 06 Jan 2025
34 points (92.5% liked)
3DPrinting
15897 readers
73 users here now
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or [email protected]
There are CAD communities available at: [email protected] or [email protected]
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
It looks to me like your printer is printing on slightly melted plastic. I don't use orca or a Bambu, so I don't know if you're able to do this, but I would try printing that section slower, or changing the minimum layer time. It looks like that's a small cross section so it's probably finishing the layer and starting the next before the previous one has cooled down.