What could cause the strange part on the right? The whole surface should be the same, it's a 90° wall, so nothing that should look like this. Can't see anything strange in OrcaSlicer. BambuLab A1 Mini with Creality PLA+
this post was submitted on 06 Jan 2025
34 points (92.5% liked)
3DPrinting
15897 readers
73 users here now
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or [email protected]
There are CAD communities available at: [email protected] or [email protected]
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Just a band. But not all the was around. It is at overhangs and a little bit after them. But not before overhangs.
If it’s only overhangs then you may want to look at increasing the time between layers or increasing the part fan speed on overhangs.
This way there’s time for the layer before to solidify enough before adding more heat and melted plastic above it.
May not be it but it does have a kind of “overheated” look to it.