Fourth try on a print. Tried to add some adhesive to the bed to get it to stick better. Watched the first two layers and went to bed. Woke up to a printer on strike.
this post was submitted on 06 Jan 2025
280 points (97.9% liked)
3DPrinting
15901 readers
170 users here now
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or [email protected]
There are CAD communities available at: [email protected] or [email protected]
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
These nozzles are cheap. And it shouldn't be very difficult fix this one if you have a heat gun. The hard part will be to get at the latch that holds the the nozzle assembly in the extruder. That's small, fiddly, and delicate part that there is a good chance of breaking.
So while you are ordering that spare heater assembly, ($20US) you might as well get a new nozzle too, ($10US).
You don't need any new parts to fix this, though, except maybe a new sock. You just heat up your hotend for a while and it'll pull off. If it's too thick, stick the hotend in the oven for a bit.