this post was submitted on 04 Dec 2024
134 points (98.6% liked)

3DPrinting

15721 readers
182 users here now

3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.

The r/functionalprint community is now located at: or [email protected]

There are CAD communities available at: [email protected] or [email protected]

Rules

If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![](URL)

Moderation policy: Light, mostly invisible

founded 2 years ago
MODERATORS
 

I made a case to protect my darts when taking them somewhere. Here are some more images. The case was made to fit a specific model and it's not very parametric till then end, so I'm afraid it's not super useful for others.

It was made in #FreeCAD 1.0 which was super smooth!

you are viewing a single comment's thread
view the rest of the comments
[–] callcc 5 points 1 week ago (2 children)

They fall out. For now I use a rubber band around the case but I don't like that solution too much. The initial idea was to put a rubber band around the "waist" so that they would be held there. Unfortunately the rubber then doesn't touch the dart. My current idea for a fix is to make a clip that pushes against that darts sideways through the holes.

[–] [email protected] 7 points 1 week ago (1 children)

If you ever printed a 2nd iteration, you could created a space for an oring to sit for each dart so it gets lightly held in place by friction

[–] kn33 3 points 1 week ago (2 children)

I was going to say to just make the end slightly undersized so when you push it all the way in, it gets held in by friction.

[–] callcc 2 points 6 days ago* (last edited 6 days ago)

It's a good idea but I'm sceptical about anything friction to hold the darts. The problem is that they have very sharp machined rings that make them very non-slippery to the fingers. I'm pretty sure those rings would file off anything they slide against very quickly.

The steel tip does not have this problem though, so adding some part that pushes against the tip might be the solution. Alternatively, i could also make the part that houses the flights be somehow spring loaded and squeeze them.

[–] [email protected] 2 points 1 week ago
[–] [email protected] 5 points 1 week ago (1 children)

If you wanted to try to make your original rubber band idea work, you could try moving the central dart up slightly so that the rubber band forms a triangle shape and adjust the contact points between the rubber band and the darts to be at each corner of that triangle

[–] callcc 4 points 1 week ago (1 children)

Yeah, I think I see what you mean. I'm very plastic conservative so I hope I can go without printing a second one, therefore the clip idea. Also the clip is a bit more practical better looking.

[–] [email protected] 3 points 1 week ago