overview for FQQD

I moderate a community that requires me to add a reason on why the posts were removed. It would be nice to have this option in Summit, so I don't have to go into the Lemmy web interface every time.

Was ist mit der Instanz los? in c/[email protected]

[–] [email protected] 5 points 5 months ago (3 children)

Also im Moment funktioniert sie wieder sehr gut :D

Beware of heckers in c/internetfuneral

[–] [email protected] 1 points 5 months ago

Tbh, you're right. Will remove. I thought that it maybe could fit if it was like - art. Or smth.

rule in c/[email protected]

[–] [email protected] 17 points 5 months ago

Yes, but only limited supply is available, so please bring your own.

rule in c/[email protected]

[–] [email protected] 4 points 5 months ago

You really don't have to be in that industry tbh

rule in c/[email protected]

[–] [email protected] 3 points 5 months ago (1 children)

Pretty sure i saw it, at least as a sticker. And they gave cat ears away.

187

Analog problems require kickass solutions (lemmy.ca)

submitted 6 months ago by [email protected] to c/[email protected]

13 comments fedilink

cross-posted from: https://lemmy.ca/post/10949982

7

GAMIN HEADSET (cdn.discordapp.com)

submitted 7 months ago by [email protected] to c/[email protected]

0 comments fedilink

GAMIN HEADSET

60

Believe your pizza (sopuli.xyz)

submitted 7 months ago by [email protected] to c/[email protected]

4 comments fedilink

cross-posted from: https://sopuli.xyz/post/5905929

9

Use Molex connector from fan to power LED strip (feddit.de)

submitted 7 months ago by [email protected] to c/techsupport

3 comments fedilink

So, I have this 12V LED Strip (not RGB) and I want to power it using my PCs power supply. I also have an old case fan with this Molex connector on the back, which should give access to 12V according to the pinout.

My plan, as you might have guessed, is to cut off connector with some cable overhang, isolate the ends on the fan side, and solder some extension wires (probably speaker wire) to the Molex connector wires.

If I now connect that wire to the LED strip, taking care to connect the ground to - and 12V to +, it should just work, right?

Are there any risks I have to watch out for? My power supply is a 600W supply, so it should have plenty of power for the LEDs. I'm 99% sure this plan should walk flawlessly - but I want to ask you guys first so I don't burn my house down.