3DPrinting

15792 readers

390 users here now

3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.

The r/functionalprint community is now located at: or [email protected]

There are CAD communities available at: [email protected] or [email protected]

Rules

No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts

If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![](URL)

Moderation policy: Light, mostly invisible

founded 2 years ago

MODERATORS

$1200 chair, $60 HOTAS, $15 filament = Spaceflight Commander (lemmy.world)

submitted 11 months ago* (last edited 11 months ago) by overzeetop to c/3dprinting

13 comments fedilink hide all child comments

<- gallery of parts

https://imgur.com/a/dkILl03

I've been wanting to try and make a mount for space gaming to go with my office chair - a Steelcase Leap. The organic-ish arms didn't make an easy way to create a clamp system, but in fooling around with it recently I noticed I could remove the armrest pads and they had a nice 4-bolt pattern. Since this is my office chair I need to be able to swap in or out of gaming setup easily.

I added a 30mm tall adapter that lets me slide a 6mm x 30mm (actually, 1/4x1-1/4) bar in and secure at the back, with a plate adapter to mount my old HOTAS4 to the bar, and a pin at at the rear for quick release.

The plates and adapters are eSun PLA+ which is fairly stiff but has some durability/ductility to it. The bar was supposed to be 6061-T6 aluminum but I was lazy and didn't feel like making a mess in the shop, ripping down some surplus plate I have, and I was too cheap to go out and buy 1/4x1-1/4 steel bar stock so I decided to print the bars from PAHT-CF (high temp nylon with carbon fiber). The 385mm bars just barely fit diagonally on my CR-10s.

you are viewing a single comment's thread
view the rest of the comments

[–] d00ery 11 points 11 months ago (2 children)

Gallery link only shows one picture for me in Sync for Lemmy

[–] overzeetop 4 points 11 months ago

Thanks for the heads up… try https://imgur.com/a/dkILl03

load more comments (1 replies)