3DPrinting

15758 readers

133 users here now

3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.

The r/functionalprint community is now located at: or [email protected]

There are CAD communities available at: [email protected] or [email protected]

Rules

No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts

If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![](URL)

Moderation policy: Light, mostly invisible

founded 2 years ago

MODERATORS

Klipper and Ender5+ are kicking my ass (partizle.com)

submitted 2 years ago by [email protected] to c/3dprinting

15 comments fedilink hide all child comments

I'll start out saying, i'm not very good with this stuff.... I have an Ender 5+.
I had it setup with octoprint and klipper from a guide I found a couple years ago, and it worked OK for me to get klipper installed, working on octoprint, and pressure advance tuned ok ish.

Recently my SD Card became corrupt, and like an idiot I didn't have anything backed up.

So I'm trying to setup the system again from less than scratch and it's kicking my ass.

I've decided i'd like to try Mainsail, as it's interface looks interesting (no other reason) But I can't for the life of me get it working.

EVERY guide I try and follow seems to fail on the connect between klipper and the printer.

I can flash the klipper firmware successfully, and have updated the port ID in the printer.cfg file, but it always comes back to klipper not being able to see/access the port.

Any help would be appreciated here.

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 1 points 2 years ago (1 children)

Found the port ID by ls /dev/serial/by-id/* I only have one usb device connected, the printer.

I didn't make a new line in the printer.cfg, just edited the [mcu] serial: /dev/serial/by-id/usbXXXXXXXX To match the id I found in the previous command.

[–] [email protected] 1 points 2 years ago

That sounds right. And "klipper" is in the XXXXXX part, right?

How did you install klipper? Are you using mainsailos, or did you install manually? Or with KIAUH? I have an ender 3 and ender 5+, both running klipper. I used the official raspberry pi imager program to install mainsailos to both SD cards, and things went fairly smoothly.

What error message are you seeing in mainsail? I'm wondering if klipper doesn't have permission to access the USB device, but that seems unlikely if you are using mainsailos.