3DPrinting

15901 readers

129 users here now

3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.

The r/functionalprint community is now located at: or [email protected]

There are CAD communities available at: [email protected] or [email protected]

Rules

No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts

If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![](URL)

Moderation policy: Light, mostly invisible

founded 2 years ago

MODERATORS

I dried my filament, and it printed a lot better (self.3dprinting)

submitted 2 years ago by zipsglacier to c/3dprinting

12 comments fedilink hide all child comments

If only there was some way I could have known to try this sooner! /s

Story: I wanted to try printing with petg, since I've read how much easier it is. But with a new roll I just had a really hard time. Lots of stringing, poor adhesion, and it just seemed like no amount of my usual fiddling would really make it better.

Somewhere I read that even new filament can benefit from drying, because maybe it wasn't stored in the best way, or maybe it's older than you think. I also read about putting the roll on the print bed, heating it up and covering it for a long time, since I don't have a filament dryer. I did that for about half a day, and then sealed the roll in a ziptop bag with a silica packet because I needed a break from it. A week later and, it seems much better!?

Either the drying, the break, or something else seems to have helped a lot! Happy printing everyone.

you are viewing a single comment's thread
view the rest of the comments

[–] bigredgiraffe 3 points 2 years ago* (last edited 2 years ago) (3 children)

I have found the same, especially with PETG and PA. I even live in a fairly dry climate (Colorado, USA) and the normal air humidity is low (15-30% is not in common) so I figured it would be okay but nope! Huge differences in print quality and layer adhesion. PLA seems to not be remotely as picky but it does help.

[–] zipsglacier 2 points 2 years ago (1 children)

oh, I've actually been thinking that people in really dry climates must have a great time; I guess the dry air alone isn't enough though!

[–] bigredgiraffe 2 points 2 years ago

Okay glad it wasn’t just me then haha. I think it was Zach from VoidStar that mentioned he lived in Denver area in one of his videos and I was like “wait a second, he has a whole dry room…” and gave it a whirl and the results spoke for themselves.

load more comments (1 replies)