I was in Sinq Liaison when I logged back in, right on the edge of Pochven. Thinking about moving over to Verge Vendor though and living in low sec. I was always a HS miner/producer but want to see what I can do in low.
ZuCo
Layers, lots of layers. I generally only use 3 layers on a regular basis and once you get used to it it's hard to go back for general typing.
I don't know if MechanicalHeadPens has been created as a community yet, maybe I'll create one unless someone has a link.
I have a Preonic at home that I swap to occasionally but every time I open a game I always reach for my staggered. The Preonic also has Kailh Box Navy Thick Clicks so it's not conducive to gaming at all in my opinion, I loved the switches when I first got them but I've grown out of them.
Thank you! I'm planning to give blending a shot on the sword, still not finished with it yet.
Thank you, it was my first try at hand routing a case. I wish I would have gone a little bit deeper but the jig and router bit I used limited the depth.
I've been switching back and forth for a couple of years now, I use an ortho at my desk, my laptop keyboard on my commute and a staggered 60% at home (still can't get used to gaming on a 40% ortho.) The staggered vs ortho switch doesn't bother me but I use home row mods on my 40's and that constantly throws me off when they are not available.
It is, I have pens that I spent a lot more money on but it's still my favorite.
I just bought my printer a couple of months ago and I was shocked at how much the prices have come down. I think the entire setup with a printer (Mars 3 ultra), cure/wash station and a bottle of resin only ran me $350 so it's not exactly cheap but a few months without latte's (if that's your thing) would pay for one. And honestly you could get away without the cure/wash station and save another $100.
Totally agree, they have some amazing sculpts. I just finished printing out their gigantic orc from May and am close to putting some paint on it; not enough time in the day.
In a way, I printed the STL from Archvillain Games on a resin printer and then painted it. Archvillain gets all of the credit for the sculpt and they do some awesome work.
This sounds like good advice, was thinking about FW.