StefanT

I was just wondering how you need to design the support when printing sideways 🙃

Looks great 👍

I got a glass bed then and simply put' it on the stock bed. Takes 5 degrees more heat and a little longer to heat up but I am very happy with it. Btw, when you are at it: I would isolate the bottom side of the bed to conserve energy. You can buy ready made isolations with a glue- and an aluminium side.

The second photo looks like there is some underextrusion involved too.

No blinking caps-lock but graphics driver problems which result in mouse hangs every couple of seconds if a second monitor is connected. Count this as +1 to "6.4 has problems"

I find systemd-boot so much easier to use and it's configuration is much smaller. So maybe consider to switch (if you are on UEFI).

Same here 👍

Quite impressive results.

Ikea uses Zigbee. Works without problems with zigbee2mqtt too.

You know their tuning page? I did several of their suggestions and they helped me. https://docs.nextcloud.com/server/latest/admin_manual/installation/server_tuning.html

I would rather convert the printer to direct drive first. There are various variations which are not expensive. I went with a cheap BMG extruder clone.

Yes.