this post was submitted on 19 Jun 2023
4 points (100.0% liked)

Guitar Pedals

1075 readers
1 users here now

This community is for the discussion and appreciation of Guitar Pedals. Post your pedalboards, ask about pedal order, stomp those boxes!

Rules:

Gear Reviews:

Buy pedals (US):

Buy pedals (Intl):

Guitar-related communities:

Guitar pedal icons created by Freepik - Flaticon
Banner from Sweetwater's Largest Pedalboard

founded 2 years ago
MODERATORS
baronvonj
[email protected]
4
Bi-amp with slow vibrato. (self.guitarpedals)
submitted 2 years ago by Stev_0 to c/guitarpedals
3 comments fedilink hide all child comments
 

I’ve been running a vibrato pedal(tc tailspin) at the end of my chain for a while. The main reason is to give me a wobbly sound without turning into a chorus when I run reverb or delay.

Last week I was experimenting with running two amps setup and found out that when I use the tailspin with bottomed out controls on one amp and nothing on the other I get a massive sound.

I was floored by how good it sounded. Especially considering the nature of the second amp.

I’m using a fender bassbreaker 112 combo and an extremely cheap and old Vantage transistor combo.

You should give this a try if you have a cheap practice amp and a vibrato pedal lying around. It’s a ton of fun!

all 4 comments
sorted by: hot top controversial new old
[–] justhach 2 points 2 years ago (1 children)

Congratulations on discovering stereo wet/dry chorus :)

It can get even more fin if you can get two different choruses going for true stereo, or (optimally) a wet/dry/wet rig for ultimate in lushness.

I remember the first time I ran my Pigtronix quantum time modulator in stereo with my amps on opposite sides of the room and just going "aaaaaaaaaaaaah i get it now".

[–] Stev_0 1 points 2 years ago (1 children)

The thing is: It doesn’t sound very chorussy at all. It just sound really beefy. If I kick the tailspin on its like I’m kicking on a boost. Is that how wet/dry usually works?

[–] baronvonj 1 points 2 years ago

Wet effects are typically modulation, time, and reverb. They output of these pedals is typically a blend of both the original input signal (dry) and the result of the effect (wet). You can split your signal chain (with a A/B[/Y] pedal) between your drive pedals and modulation pedals, and send on output straight to an amp (dry) and the other through the wet effects to a second amp (or two if you have stereo modulation/delay/verb). You might have the dry amp adding it's own gain.

Some stereo modulation doesn't actually do left/right panning, but instead does wet/dry "stereo." So you could use a chain of pedals that work like that instead of an A/B pedal to split your signal for wet/dry.