Guitar Pedals

1049 readers

6 users here now

This community is for the discussion and appreciation of Guitar Pedals. Post your pedalboards, ask about pedal order, stomp those boxes!

Rules:

No affiliate links directly in your posts/comments
Linking to your own reviews/demos is allowed
This is not a classified ads forum, no buy/sell/trade posts
- Asking for recommendations about what to buy is fine
- Asking for advice on a listing you've found is fine
- Links to retailers found below

Gear Reviews:

60 Cycle Hum
Andertons
Andy Demos (formerly Pro Guitar Shop Demos)
JHS Pedals
That Pedal Show
The Guitar Geek

Buy pedals (US):

Buy pedals (Intl):

Guitar-related communities:

Guitar pedal icons created by Freepik - Flaticon
Banner from Sweetwater's Largest Pedalboard

founded 1 year ago

MODERATORS

baronvonj

[email protected]

Bi-amp with slow vibrato. (self.guitarpedals)

submitted 1 year ago by Stev_0 to c/guitarpedals

3 comments fedilink hide all child comments

I’ve been running a vibrato pedal(tc tailspin) at the end of my chain for a while. The main reason is to give me a wobbly sound without turning into a chorus when I run reverb or delay.

Last week I was experimenting with running two amps setup and found out that when I use the tailspin with bottomed out controls on one amp and nothing on the other I get a massive sound.

I was floored by how good it sounded. Especially considering the nature of the second amp.

I’m using a fender bassbreaker 112 combo and an extremely cheap and old Vantage transistor combo.

You should give this a try if you have a cheap practice amp and a vibrato pedal lying around. It’s a ton of fun!

you are viewing a single comment's thread
view the rest of the comments

[–] baronvonj 1 points 1 year ago

Wet effects are typically modulation, time, and reverb. They output of these pedals is typically a blend of both the original input signal (dry) and the result of the effect (wet). You can split your signal chain (with a A/B[/Y] pedal) between your drive pedals and modulation pedals, and send on output straight to an amp (dry) and the other through the wet effects to a second amp (or two if you have stereo modulation/delay/verb). You might have the dry amp adding it's own gain.

Some stereo modulation doesn't actually do left/right panning, but instead does wet/dry "stereo." So you could use a chain of pedals that work like that instead of an A/B pedal to split your signal for wet/dry.