Home Improvement

I think this is an advert

Reminds me of this OpenSCAD design: https://www.thingiverse.com/thing:281520

It seems like those are for bags and backpacks. Coats, jackets etc might slip from rounded wide hook.

I didn't see the the most popular colour - (off)white.

Usually I buy hooks for towels and those benefit from 2-3 hooks on single mount.

Also I usually never buy hooks only, I buy them fitting to other furniture or space.

If I were you, I'd become a supplier to bigger store. Alternatively I'd adjust the design for custom mounts for popular models of light transport (scooters, ebikes)

PLA is a poor choice for this application. PLA will permanently deform under constant load (creep) even at room temperature. Hanging things on a hook is definitely a constant load -- especially up to 45 pounds worth of something. These may not fail under short term static testing at that weight but I can tell you they absolutely will not withstand that type of load for an extended period. They're probably fine for very light duty hanging, however. I have a variety of PLA pegs and hooks around the place that are at most holding a couple of ounces in some cases for 2+ years and they have not appreciably deformed, or at least not to the extent that I've noticed enough to care.

But to avoid the inevitable customer complaints of this ilk, I advise you to either lower your advertised load rating or print these out of ABS or ASA, or at the very least PETG if your machine can't handle the higher temperatures required for ABS reliably. Polycarb would be even better but it is extremely difficult to print with consumer printers and is probably more trouble than it's worth. Out of the "normal" non-exotic, non-super-high-temp filaments readily commercially available, ABS has the best creep resistance.