this post was submitted on 03 Feb 2024
15 points (100.0% liked)

Machinist

673 readers
1 users here now

From Newcomers to Old Timers, a community united by the Industry of Machining

Rules Don't post illegal stuff

Don't post Porn (no sexy aluminum surface finishes don't count)

Don't be an asshat (harassment, bullying etc.)

If you're going to post NSFW stuff, flag it as NSFW, It's ok to post shop Screwups (blood/cuts) just make sure to flag it as NSFW

and Finally make sure to have a good time :D

founded 1 year ago
MODERATORS
 

Need some help with overcoming the initial hurdles of a learnjng curve. I'm in a fake it till I make it type situation right now. We acquired most of the equipment that a machine/fab shop would have and most of them, there is plenty of information online to learn from. Except for the horizontal boring mill, and I am struggling. The tooling all needs to be made up for it. Nothing I can purchase direct. The spindle is a MT6. My supplier can only get me reducers to MT5. And setting up parts is quite time consuming.

Any advice or know how on being able to turn a profit on this machine would be appreciated.

The machine is a TOS W100 in mostly good working order. Apart from the boring head dropping 0.020" if I cut in reverse travel after forward travel cutting.

Thanks

all 7 comments
sorted by: hot top controversial new old
[–] ganksy 4 points 9 months ago (1 children)

I found this on YouTube looking for your machine. Maybe you've found it too. It looked like a review but the guy goes through quite a few of the ins and outs. It's a TOS 100A but the only real difference is the travel of the cross slide.

https://youtu.be/jM0l3HLChG8?si=5NE9NH-Wo6tmdj0Q

As for how to make money with it, I would imagine construction equipment repair would be a nice entry. Like the kind of work Curtis at Cutting Edge Engineering does.

Wish I could help you with first-hand experience but I have none. GL!

[–] Mpatch 2 points 9 months ago

Thanks! That was one of the first things I watched on that machine. Of all the equipment we got over the past few years, this one was just droped off at the door I didn't even get a chance to talk to previous operator.

Yes the work that Curtis does is incredible. And I am in a similar line of work. Just years behind in experience and knowhow.

[–] [email protected] 2 points 9 months ago

I don't know about that, I run a horizontal exciting mill.