this post was submitted on 03 Feb 2024
15 points (100.0% liked)

Machinist

674 readers
1 users here now

From Newcomers to Old Timers, a community united by the Industry of Machining

Rules Don't post illegal stuff

Don't post Porn (no sexy aluminum surface finishes don't count)

Don't be an asshat (harassment, bullying etc.)

If you're going to post NSFW stuff, flag it as NSFW, It's ok to post shop Screwups (blood/cuts) just make sure to flag it as NSFW

and Finally make sure to have a good time :D

founded 1 year ago
MODERATORS
[email protected]
15
Any old timers run a horizontal boring mill? (self.machinist)
submitted 9 months ago by Mpatch to c/[email protected]
5 comments fedilink hide all child comments
 

Need some help with overcoming the initial hurdles of a learnjng curve. I'm in a fake it till I make it type situation right now. We acquired most of the equipment that a machine/fab shop would have and most of them, there is plenty of information online to learn from. Except for the horizontal boring mill, and I am struggling. The tooling all needs to be made up for it. Nothing I can purchase direct. The spindle is a MT6. My supplier can only get me reducers to MT5. And setting up parts is quite time consuming.

Any advice or know how on being able to turn a profit on this machine would be appreciated.

The machine is a TOS W100 in mostly good working order. Apart from the boring head dropping 0.020" if I cut in reverse travel after forward travel cutting.

Thanks

you are viewing a single comment's thread
view the rest of the comments