this post was submitted on 21 Aug 2023
64 points (97.1% liked)
Cast Iron
2048 readers
1 users here now
A community for cast iron cookware. Recipes, care, restoration, identification, etc.
Rules: Be helpful when you can, be respectful always, and keep cooking bacon.
More rules may come as the community grows, but for now, I'll remove spam or anything obviously mean-spirited, and leave it at that.
Related Communities: [email protected] [email protected] [email protected]
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
I use stainless steel cookware so I can scrub the shit out of it without worrying about anything
Contrary to popular belief, you can scrub your cast iron, too. The seasoning (if done correctly) is bonded at a molecular level to the cast iron, so even a hard go with a steel scrubber wont take it off.
Should you do this regularly with a strong soap? No, but its better to scrub off some burnt on bits than leave it on because we think cast iron seasoning will be ruined is we look at it funny.
But if you're cooking with it right, that shouldn't happen too often.
Is there a trick to getting stainless to release food in a reasonable way? I've tried it a couple times and whatever I cook ends up feeling like it's epoxied on. I assume it's a me problem since so many people speak positively about it.
Throw some water and dish soap in it and simmer for like 5-10 minutes. It'll loosen everything right up.
Or, what I usually do is fill it with hot water and soap as soon as I'm done with it so by the time I'm done eating it's good to go.
Is your stainless single ply? I just went back to stainless (and cast iron) after not using it since I was a kid, and have the opposite question. When I was a kid, it was horrible how everything stuck or burned, and such a pain to clean. Now I pretty much never have a problem with anything sticking.
But I have to wonder if it’s me finally getting the hang of cooking, or is it mostly old single ply stainless vs new 5 ply?