this post was submitted on 27 Jan 2025
191 points (99.0% liked)
Dull Men's Club
1795 readers
300 users here now
An unofficial chapter of the popular Dull Men's Club.
1. Relevant commentary on your own dull life. Posts should be about your own dull, lived experience. This is our most important rule. Direct questions, random thoughts, comment baiting, advice seeking, many uses of "discuss" rarely comply with this rule.
2. Original, Fresh, Meaningful Content.
3. Avoid repetitive topics.
4. This is not a search engine
Use a search engine, a tradesperson, Reddit, friends, a specialist Facebook group, apps, Wikipedia, an AI chat, a reverse image search etc. to answer simple questions or identify objects. Also see rule 1, “comment baiting”.
There are a number of content specific communities with subject matter experts who can help you.
Some other communities to consider before posting:
5. Keep it dull. If it puts us to sleep, it’s on the right track. Examples of likely not dull: jokes, gross stuff (including toes), politics, religion, royalty, illness or injury, killing things for fun, or promotional content. Feel free to post these elsewhere.
6. No hate speech, sexism, or bullying No sexism, hate speech, degrading or excessively foul language, or other harmful language. No othering or dehumanizing of anyone or negativity towards any gender identity.
7. Proofread before posting. Use good grammar and punctuation. Avoid useless phrases. Some examples: - starting a post with "So" - starting a post with pointless phrases, like "I hope this is allowed" or “this is my first post” Only share good quality, cropped images. Do not share screenshots of images; share the original image.
.
founded 3 months ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Very nice! How did you go about it?
I picked up a piece of hardwood that was 5/8 inch thick. Just measure the gap under your door so you know how tall the threshold can be. I went with a 3.5 inch width to cover the floor's expansion gap with room to spare. I just cut that down to the width of the door. Then I used a router to put a 45 degree chamfer on all 4 sides.
The 45 degree angle goes down about half way, I just ran a scrap piece through the router and progressively raised the bit until the angle felt right, then did it on the final one.
Gave it a light sanding to remove any splinters and then I just stained it to match the floor and used a rubber mallet to get it in place. It's pressure fit, so it's a little tight to hold it in place. Some people opt to screw them into the floor below instead.
Dropping a few brads/nails into it to hold it into place is a good idea. As time goes by, wear and expansion/contraction of the flooring will have it popping out.
I picked up an airgun to put in 2 1/2" finishing brads on the floors I did (engineered hickory). Turned the air pressure up to the maximum the gun was rated for (150psi) and sunk the brads into the board
That's a good idea, thanks!
I also hope you did 5+ coats or so of polyurethane or shellac on it. Jams tend to take a beating. The slight rise means that everything hits them. I had to learn that one the hard way.