I have 4 RGB+C+W zigbee bulbs like this one:
However after adding it to home assistant, they only show up as c+w bulbs:
What am I doing wrong? How can I get it to detect it as RGB+C+W?
this post was submitted on 26 Nov 2024
6 points (100.0% liked)
homeassistant
12153 readers
30 users here now
Home Assistant is open source home automation that puts local control and privacy first. Powered by a worldwide community of tinkerers and DIY enthusiasts. Perfect to run on a Raspberry Pi or a local server. Available for free at home-assistant.io
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
What ZigBee Coordinator do you use? I know deconz and zigbee2mqtt have the ability to add support for new devices via config files. But that's a bit of a rabbit hole into the ZigBee protocol. They also have forums/issue trackers where one can request support for new devices.
I'm using the ZHA connector, these are Tuya bulbs, I've had good success with other Tuya products but alas. ~ Where would I requested support?
There is some documentation in the forum about how to add new device support or where to request it. Read it and then decide what to do.
I found someone who, just yesterday, submitted a device support request for my exact model! The request is here, I'll watch it for a bit.