The unit "hertz" means "per second". A higher value is still one second, but more events per second.
thenewred
joined 2 years ago
The only thing spicy in Ukraine is horseradish
But you make ten coffee tables and you break even. And then it's all profit
I used PLA+ with no complaints so far
It worked pretty well for the ~10 long thin rips I did.
Holding up fine even after dropping it. Definitely works. And I decided to print the model I found with modular bits so I could reprint and replace the broken feathers when that eventually happens, instead of reprinted entire body.
I wish I could give you an academic answer, but I was going off of a similar design and thought if it works there, it should work here.
Honestly I'm a bit worried about the corners, but they feel stable enough.
I used pocket screws and wood glue at each shelf attachment to the frame. The shelf slats are all glued edge grain to edge grain, so in theory the entire shelf should act like a solid board.
I can barely code fibonacci, doubt I could model it
Ender, prusa, bambu are names that have popularity, longevity, and reputation.
You can find a ton of recommendations and best printer lists with a quick search. You would probably be fine with most printers on those lists if you wanted to save some money, but the above three are solid and give you a good budget range already.
There's a little bit of movement but it's not too annoying. When loaded up with belts, taking one off doesn't make a big difference.
Agreed, it was a ton of work. The back of the saw was definitely the biggest struggle because of how the motor moved when adjusting tilt and height.
Sealing the blade shroud might have worked. I'd probably try that first if I did this again.