.05 on my ender 3 s1 sounds perfect based on the tolerance tests I've run. Thanks!
neal33
Thats a very fair point. I've done tolerance tests with mine and can get away with 0 with some encouragement and .05 just fine. Thanks!
Just curious, when making this how much tolerance did you account for? I want to make some for baseball teams, but wasn't sure how much to add.
Something is blowing in. It's very windy here. Only gets like this before a storm.
Shouldnt be the filament then. I would make sure the probe is fully secured like the other comment suggested. Good luck, that sounds frustrating! I need to adjust mine, but usually after printing for a couple weeks.
What type of material are you printing? Could be the material is eating away at the brass nozzle causing you to need to adjust the z offset.
Similar results with my Ender 3 S1. Highly recommend!
A hair away from a game 5 😔
I hate how much this reminds me of the 90s. Best offense in baseball to first round exit. It stings now. And unfortunately overshadows an amazing season. 40/70, Olson's records, tying the all time home run, Strider and his strike out pace. Ugh!
Well that sucked. Need to win game 2 on Monday.
Even if it wasn't part of the software that would take minutes to splice together assuming you have access to all feeds (which they do considering it's on their property).
I had a similar issue when I initially installed Klipper on my Ender 3 S1 (not the plus). It would not connect unless I fully restarted Octoprint whenever I turned on the printer. The change I needed to make was go into settings in Octoprint (though I assume its similar on other front ends), and add the following settings:
Serial Port: /tmp/printer
Baud Rate: 11520
If that is not the case for you, try to add some more details. Do you have the config file correct?