Today I F'd Up

223 readers

1 users here now

Post titles must begin with "TIFU by".
Post must be about you, and a legitimate mistake that is your fault.
Post must not be offensive, illegal, or gratuitously shocking, and flagged NSFW where appropriate.
No ads or self promotion.
Follow the Sopuli Rules.
Don't annoy the mod(s).

founded 2 months ago

MODERATORS

[email protected]

113

TIFU by using a hammer drill a little too eagerly (lemmy.world)

submitted 1 month ago* (last edited 1 month ago) by valkyre09 to c/[email protected]

20 comments fedilink hide all child comments

I pushed the drill a little too hard from the other side. Didn’t realise the damage I’d done until I came around the other side to my wife shouting and screaming. ¯\(ツ)/¯

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 23 points 1 month ago (2 children)

This will happen every time you use a hammer drill because that's just how they work - by hammering.

Protip: use way smaller bit first to go all the way through as a pilot hole, then use the size you need and drill from either side to stop it from blowing out like this.

[–] [email protected] 5 points 1 month ago* (last edited 1 month ago)

I've often found you don't even need the hammer aspect, just using a mason bit will work, especially for softer materials. It'll take longer, but if it's only for the finish, it's faster than fixing a blowout like this.

Alternatively turn off the hammer for the finish, or finish the hole from this side (since you have the pilot hole). This works well on any material, for example to prevent blowouts on wood or flash on metal.

[–] [email protected] 3 points 1 month ago

Also with older/crappier walls you may need to use one size smaller than you acutally need.