This morning I woke up to my phone using mobile data and my home assistant automations not working. Initially I thought it the power was out, but I could turn on the lights just fine. I checked my UniFi app and saw that the server was not connected to the network at all. This meant that the cable got unplugged, the switch isn't working, or the server isn't working. It said the switch was connected and another device was connected to the switch so that narrows it down to just 2 cases. So I opened my server closet in the basement and immediately noticed something was wrong. I couldn't figure out what was wrong but I just felt like something was wrong. Everything was plugged in, the network switch lights were blinking like normal, my raspberry pi was running just fine, even the server indicator lights were on. My main server is an old gaming PC so it has a glass side panel so I looked inside and I could see the fan spinning, but I could not hear it. Usually I have it set to full speed and I can hear full speed very well. I tried rebooting the server with the power button and the fans didn't go to full speed. As a last resort, I brought down a keyboard and monitor. As soon as I plugged in the monitor, I saw that there was a prompt to set the time on the BIOS! Picture of the prompt In my opinion, this was the stupidest reason for an outage.
Further investigations
I dug a little deeper and discovered that the BIOS had been reset during a power outage right before all of this happened. So far I have consulted the motherboard manual and found absolutely nothing about this. After a bit of research, I think it could have been that the CMOS battery has died. This is a really simple fix but I don't have the replacement battery right now. This means that I will have the same exact issue after the next power outage unless I replace the battery.
Preventing this in the future
From what I can see, I just need to replace the CMOS battery. But this computer has been running for over 4 years, so what is stopping this from happening again around 2028? The most effective solution is going to be preventing power outages in the first place. This can be done using a battery backup or a standby generator. Standby generators will last longer during a power outage but are typically more expensive and harder to setup than a simple battery backup.
Why you are at it you might want to check the battery in your smoke alarm. I think your are support to change the smoke alarm battery every 5 years.
The battery in smoke detectors should be changed every year and you should ideally test the detectors using the little button monthly.
In Norway we have an official smoke detector day which is on December 1. where we're supposed to change the batteries. Its because Christmas is the high season for house fires.
That depends on the type of battery. I have some of the old school ones, which are "test every 6 months, replace every year," but also a fancy schmancy lithium ion-powered one that should be good for 10 years (so test every 6 months, but replace after 10 years).
Yea the lithium-ion batteries are pretty good, you can also get 10 year smoke detectors with a built in lithium battery. Also a psa, smoke detectors usually only last 10 years and need to be replaced after that. There's often an expiry date on the detectors.
Just took over a house last year with smart detectors connected to a homebase, all Li-Ion. Can see the battery percentage in the app. No more December 1st checks for a long time!
It is 5 years in the US as it says it on the box. The battery can last 10 years but that is way to long from a safety perspective.
Lithium batteries last 5-10 years, regular 9v alkaline batteries last about 12-18 months. Some sources recommend changing the batteries every 6th month but i personally think that's a bit excessive.
I only have a small 2 room apartment so i just got myself a cheap-ish optical smoke detector with a built in lithium battery. The battery should last 10 years which is how long smoke detectors last before they should be replaced.