this post was submitted on 28 Jul 2024
17 points (90.5% liked)

Woodworking

6603 readers
39 users here now

A handmade home for woodworkers and admirers of woodworkers. Our community icon is submitted by @[email protected] whose father was inspired to start woodworking by Norm and the New Yankee Workshop.

founded 2 years ago
MODERATORS
[email protected]
17
Does anyone have a trick for this problem with self-driving screws? (lemmy.ca)
submitted 6 months ago* (last edited 6 months ago) by [email protected] to c/[email protected]
8 comments fedilink hide all child comments
 

Situation: using a screw gun to drive in the self-driving screws (the star shaped ones) horizontally, and sometimes at a difficult angle above my head. Hard to get good leverage like that. The driver starts spinning the screw but it doesn’t catch right away and then the screw jumps out and falls on the ground.

Has this happened to you? Is there a trick for that?

you are viewing a single comment's thread
view the rest of the comments
[–] [email protected] 4 points 6 months ago (1 children)

If you mean phillips head, then fins the right sized bit. they look similar but the right size grips the screw properly

[–] IMALlama 2 points 6 months ago

Completely agree. It's also worth saying that worn Phillips bits don't perform as well as ones with less wear. If OP is using a cordless drill, use the clutch to avoid the bit caming out.