homeassistant

12071 readers

4 users here now

Home Assistant is open source home automation that puts local control and privacy first. Powered by a worldwide community of tinkerers and DIY enthusiasts. Perfect to run on a Raspberry Pi or a local server. Available for free at home-assistant.io

founded 1 year ago

MODERATORS

[email protected]

Discover devices in VLAN (self.homeassistant)

submitted 4 months ago by peregus to c/homeassistant

7 comments fedilink hide all child comments

I've a VLAN dedicated to IoT devices and, of course, HA can't discover them. Is it possible have them discovered by HA via MQTT? Create them manually it's a pita because they're a lot and I would have to create sensors/switches + battery level + RSSI Thanks!

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 18 points 4 months ago (3 children)

is there a reason you can’t put your HA in that VLAN too? if it’s a segregated, non-networked environment then why not create a second network adapter for your HA and give it an address in that VLAN too?

[–] [email protected] 11 points 4 months ago

This is the right way!

VLANs typically can only cross communicate via the gateway, most broadcast discovery protocols don't get routed via the gateway (because its not considered local), and while you can get the gateway to repeat some traffic, its very brittle... lots of network stack developers made assumptions about broadcast packets being on the local network segment.

[–] peregus 5 points 4 months ago

Well, I haven't thought about it, I can't see any drawback. Thanks!

[–] peregus 2 points 4 months ago (1 children)

I've added an extra NIC that is in the IoT VLAN, but there are no new devices. The NIC is ok, because I see that it gets the IP from the router. What can I check/run?

[–] [email protected] 1 points 4 months ago (1 children)

can you ping one of the IoT devices from the HA device on that new NIC?

can you manually add a device and HA see it/add it normally?

is there a firewall routing between HA and the IoT devices that might be blocking discovery somehow?

[–] peregus 1 points 4 months ago

I can ping the devices. No firewall, the NIC is directly in the VLAN and the Proxmox firewall is off. How can I add a device manually? ...I'm just starting with HA.