Mechanical Engineering

209 readers

1 users here now

Welcome to the Mechanical Engineering Community!

Rules:

1.) Be constructive and respectful.

2.) No advertising/self-promotion.

3.) No low-effort posts.

4.) No "design this for me" posts.

5.) Images must be relevant to Mechanical Engineering or the posted topic.

6.) We're not doing your homework for you.

founded 2 years ago

MODERATORS

Alteon

Struggling to select the right fin geometry and material, any tips ? (hilariouschaos.com)

submitted 6 months ago by [email protected] to c/mechanical_engineering

4 comments fedilink hide all child comments

Hey folks, I'm working on a project involving the design of a heat exchanger, and I've hit a bit of a wall. I'm trying to optimize the fin design for maximum thermal efficiency while keeping the pressure drop within acceptable limits. I know the general principles, but I'm struggling with the specifics of selecting the right fin geometry and material.

Any tips or resources you could recommend for tackling this?

Appreciate any advice from those who've been down this road before!

you are viewing a single comment's thread
view the rest of the comments

[–] j4k3 2 points 6 months ago

If you're doing practical design, it is hard to beat empirical observation. While you could get crazy with test setups, it is not necessary.

a bright lighting setup will allow you to capture maximum frame rates, even with your phone.
think about your background and use anything you have on hand like a black tee-shirt, but think about contrast. Most cameras use a point of sharp contrast to focus, so setup with this in mind.
ideally, use a vape pen as your smoke machine. These make an ideal dense smoke source for cheap. Alternatively, an ultrasonic fog setup can do some very small scale stuff, but is a joke next to a vape pen setup.
if you can duct air in a way that partially restricts flow to a fan, you can use the voltage or the RPM to determine how iterations compare to each other without an expensive qualified measurement tool or calibration.

That's what I messed around with when designing and comparing various 3d printer tool head duct designs for part cooling.