New ceramic burrs.
I typically use light roast beans, apparently ceramic is better there.
Went through the hyperalignment procedure and got close but not perfect. Had to move on and get it back together at some point.
Works the same, just inline. And this grinder has two
I don't know about best, but these have been decent
Slurping Turtle (Easton)
Wild Ginger (Hilliard)
Aki Hana (Henderson)
Me writing my resume in third person
Is this comparing total number of visitors per year to inhabitants?
If so, it's a misleading graphic because visitors only stay for a week or two.
A blessing! Free credit monitoring! All is well
Free solo*
But with a harness full of gear for extra weight reasons
And gloves because less grip == good?
Me, spending hours on Age of Empires 2 and loving it
Janice from The Sopranos
We water by soaking the plants in the tub, then letting them sit on towels before going back on the shelf. A bit tedious but only has to be done every 1-2 months.
True with crimps, not as important with pinches, which is what this mug is
Designed this storage solution for belts
https://www.printables.com/model/519768-belt-organizer-hanger-6-or-8-belts
Had minimal clearance between these overhead shelves and the garage door, and the perfect light spacing was a few inches away from the cross bars. So I designed these snap fit brackets to offset the lights inline.
The lights make a huge difference, much more pleasant to work in the garage.
What I learned:
Also printed cable management clips
Made entirely from 1x2 pine. Ripped into thirds for the shelf slats. Pocket holes. Glue. Brads and glue for the shelf slats.
I might have crossed my wires, it was probably just a forum post I misread. I happened to have new ceramic burrs so I went ahead and installed them.
I got closer to a perfect pull this morning after adjusting the right lever! Unfortunately I'm out of that coffee now so the process restarts with the next bag.