To be honest I just took the profile from Prusaslicer. I did tweaked a bit during the print but it was like the extruder could not grasp the material. the clicking came from there. When I took it out again there were gaps in the filament itself.
For the yellow I had a successful first layer, the green was a disaster from the start. I now made a dehydrator from a cheap food thing and I hope that it's not all wasted ..
From what I remember it was 215 first and then 210 other layers. But I tried tweaking when printing and didn't notice a difference. It was like the extruder could not grasp the filament correctly. I even tested with the speed but it kept clicking, its like it couldn't grasp it
That said the yellow was good for the first layer, but then the green was a complete NO. I am now drying the yellow and hope it will print.
I never had to dry filament before. This is the dryest room in my home and we do not live in a "wet air" climate. EU, Belgium. at least not anymore, and not inside. Never had any issues .. except now with this Chinese PLA.
we'll see 🤞
That said I'm using the default profile for the filament from Prusa. Gotten so used to "it just works" I kinda forgot that .. well to tweak more. lol
What temps do you use?