Does this process work for let’s say DRM encrypted music too?
No. These use Widevine DRM.
As you can tell from the security section of the article, it is not exactly impossible to crack, and I'm certain private groups have their own way to get past it.
But if you're just looking for audio, then you can just record your computer's output audio stream.
Steam Deck is based on Arch Linux & folks are trying to get as close as possible on their other PCs I assume.
PS For future reference, does this sort of exposed PCB trace (pad?) used for electrical connection take solder well?
I can't tell if you have gold plate or just raw copper (probably gold. But in either case, yes, it is solderable. You can think a little bit about how they manufacture the boards. First the print on the green solder resist, then they dunk it into an electroplating bath for a gold finish, or a dunk it in solder for HASL. It would be a lot of trouble to go through (=$$$) to individually mask off that part of the board for some special process.
Open it up!
They put a regular old switch inside a fancy box, but you'll be able to read the part number once you see the actual switch.
Unless you've managed to get a switch made out of superconducting material and you're working inside a liquid helium bath, everything has resistance :)
You'll have a bad time trying to measure such low resistances, so usually you can look at the datasheet for the switch you're using or for a similar switch if you need a ballpark number. You'll see an on-resistance, and a max current (since there will be arcing when you open the switch).
If you do want to measure the low resistance, you'll need dedicated meter with a kelvin connection.
There's not enough pixels to really check for issues, but it looks very neat! Nice work!
that's a good question--I've always just gotten the concave chisel tip because they're the same price and I didn't see any drawbacks to it under any circumstances.
I do tend to do a lot of work like this with K-tips, and those don't have a cup. I imagine that the non-concave tip would work ok. I would give it a try with your current equipment, and then think about getting a new tip if you end up doing this more.
Interesting! So this would end up meaning that you'd need to send new gerbers between production runs?
Or is this one of the edits that the fab house does to the gerbers without customer intervention (once asked, of course).
You're kinda right? It'll be harder for links to be considered authoritative by google since they'll be across a bunch of smaller websites with fewer references to them (unlike reddit, which is 1 website with billions of links to it).
But maybe it'll work somewhat anyway since every page has "Join Lemmy" text in the bottom & google might be able to link them together.
On the other hand I have no idea and I'm just going off my vague understanding of how the google algorith m works.
Bonus points if you can identify what this device is without me posting the uncropped picture ;)
I've seen different numbers in the same font on many circuit boards. What does it typically mean?
You can find a copy of the wiki on the internet archive: https://web.archive.org/web/20230424193301/https://old.reddit.com/r/AskElectronics/wiki/index
There's been a big effort in the last few days to scrape & download much of reddit
1