this post was submitted on 12 May 2024
23 points (89.7% liked)

Vaporents

950 readers
1 users here now

This is for discussion on dry herb vaporizers and showing off your setups.

founded 1 year ago
MODERATORS
 

I saw this picture of the internal heating elements of the mighty. I hadn't seen it before so I wanted to share!

Pretty neat: you can see the thermocouple in the bottom left of the heating chamber to track temp, the air path spirals up the element picking up convective heat, and you can see the hottest spot is in contact with the herb bowl which gives it the conductive heating. Superbly designed device!

top 9 comments
sorted by: hot top controversial new old
[–] [email protected] 2 points 6 months ago (3 children)

The greatest vaporizer. I've had mine for almost 7 years now and it still works great. I did replace the batteries a couple years ago and that made a big difference in returning the battery life to what it was like when new.

[–] [email protected] 2 points 6 months ago (1 children)

Wow, that's an impressive lifetime! What batteries do they take? I was guessing maybe Molicel 18650's? When I saw the picture I was the first thing I was thinking about.

[–] [email protected] 3 points 6 months ago

I used Panasonic NCR18650GA 3500 mAh 10A batteries with tabs. So far they've been great.

[–] [email protected] 1 points 6 months ago (2 children)

Do you mind if I ask, how much flower do you normally load for a session?

I'm trying to find a good solution for 2 people as I don't really want to haul volcano bags outside with me.

[–] Aecosthedark 3 points 6 months ago

I use the dosage caps, you can change them in seconds. I haven't used the volcano since getting the Mighty+

[–] [email protected] 2 points 6 months ago

I believe it comes out to about .15-.16 grams per capsule. I scoop it up with the capsule and then pack a little more on top and squish it a bit with my finger. It's the perfect amount for 2 people.

[–] [email protected] 1 points 6 months ago (1 children)

How difficult was it to replace the batteries?

[–] [email protected] 5 points 6 months ago* (last edited 6 months ago) (1 children)

It wasn't too bad. Took maybe an hour to complete. You'll need to do some soldering and you'll need to rebuild the internal battery assemblies with some kapton tape. Pay particular attention to how the wires are run on the assemblies or you'll have difficulty making the case fit back on. Honestly the most difficult part was sourcing the batteries with the tabs already welded on. While I'd love having a battery tab spot welder, I just don't think I would use it enough to justify the space to keep one around.

[–] [email protected] 1 points 6 months ago

IIRC it can be done with a bunch of 9v batteries connected together