this post was submitted on 27 Mar 2024
1007 points (99.1% liked)

Memes

46017 readers
1932 users here now

Rules:

  1. Be civil and nice.
  2. Try not to excessively repost, as a rule of thumb, wait at least 2 months to do it if you have to.

founded 5 years ago
MODERATORS
[email protected]
[email protected]
[email protected]
[email protected]
1007
Even paper glows (lemmy.world)
submitted 9 months ago by renzev to c/[email protected]
171 comments fedilink hide all child comments
 
you are viewing a single comment's thread
view the rest of the comments
[โ€“] Olgratin_Magmatoe 5 points 9 months ago (1 children)

It's actually easier with 3D printers in some ways.

3D printers:

  • Only one extruder needed
  • Parts are easy to source (basic aluminum extrusions, stepper motors, wires)
  • There software is easy to find online and install
  • The accuracy needed is pretty lax

2D printers

  • Can get away with 1 color, but 4 if you need full color which gets complicated fast. Granted 3D printers aren't much better on this front
  • The parts are not easy to source. They're often proprietary and therefore expensive
  • Good luck finding software for it
  • The accuracy needed for printing is far higher than 3D printing

There are open source 3D printers, and quite a few of them. To my knowledge, there are no 2D printers that are open source. At best you can find instructions on how to hack proprietary ones.

[โ€“] Mango 1 points 9 months ago

I want a full color 3d printer.