this post was submitted on 05 Jul 2023
22 points (92.3% liked)

Smoking

339 readers
1 users here now

a place to discuss meat smoking and roast the occasional lost teenager who posts a question about cigarettes.

founded 1 year ago
MODERATORS
 

i've never made an awesome brisket. i've made a few ok briskets. this was neither. it was a lesson in humility. i am not skilled enough to take a questionable piece of meat and turn it into amazing bbq.

so please ruminate on this pic and leave your best desert puns below. but then please also leave me a good brisket chili recipe because i need one, badly.

you are viewing a single comment's thread
view the rest of the comments
[–] julesiecoolsie 6 points 1 year ago (2 children)

A clear case of your temp being too high. I'd do max 200 degrees, and wrap it in butcher paper after smoking for a couple hours to retain moisture

[–] i_had_name 4 points 1 year ago* (last edited 1 year ago) (1 children)

I think it depends on your smoker but in general I think this is the right approach. Lower the temp and wrap when the bark is looking good. Pull when at temp, or even a bit under.

[–] julesiecoolsie 2 points 1 year ago

Yup. At higher temps this becomes grandma's roast beef and potatoes

[–] [email protected] 1 points 1 year ago (1 children)

Do you always cook beef max 200? Or is that your advice for my flat today?

And I wrap everything with butcher paper at the stall.

[–] [email protected] 2 points 1 year ago

So, the food science angle is that with tough cuts of meat, you need low and slow heat so you have appropriate time to break down the collegen in the meat. Pulled meats like chicken and pork shoulder need to end up round 200 degrees after a long cook. I havent messed with brisket so Im not sure of the right temp but I would follow with the advice kf the butcher wrap and a low cooking heat to get it the rest of the way to target after bark.