homeassistant

12139 readers

9 users here now

Home Assistant is open source home automation that puts local control and privacy first. Powered by a worldwide community of tinkerers and DIY enthusiasts. Perfect to run on a Raspberry Pi or a local server. Available for free at home-assistant.io

founded 2 years ago

MODERATORS

[email protected]

How do I add a cool down to an automation? (lemmy.today)

submitted 1 year ago by [email protected] to c/homeassistant

11 comments fedilink hide all child comments

I have an automation that turns my driveway lights on when motion is detected. It normally works fairly well but it was windy last night and that caused the automation to trip endlessly as my trees and bushes were whipping around. Lights would come on, shut off 10 minutes later, then turn right back on again. It basically did this all night until I disabled the automation.

I'll do some fine tuning of the motion sensors which will help and I'm considering adding a condition to the automation where it won't trip if the wind speed is above a certain level but how can I add some kind of cool down timer to the automation to prevent it from endlessly engaging?

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 6 points 1 year ago (1 children)

You could use mode: single, and then add a 10 minute delay onto the end of the actions.

[–] [email protected] 1 points 1 year ago

That's a good suggestion, I'll have to think on that one.